A few little jobs today, lots of work and not a lot to show but all needs doing.
First was to fit the horn, straight forwards job of drilling a hole, fitting a rivnut and connecting up the wiring harness.
Next was the speedo sensor, this needs to sit 1-2mm above the heads of the bolts which attach the propshaft to the diff. As the bolts pass they create a magnetic current which is interpreted by the speedo and shows the speed of the car. Quite difficult to get lined up as its a tight space but overall an easy job.
Final job now the sensor and bracket were in, was to attach the drivers side tunnel panel. Same as the other side, but this was all predrilled and ready to go so simply ran a bead of sealant and riveted in place.
No comments:
Post a Comment